Exchange Platform

Author: h.gras
Type: Example
Downloaded: 172 times
Date: 2022-03-18

Vary parameters, start simulation and export scope waveforms by script

Description:
This script is a simple example to learn how to script.
The script is started from the EMTP design by double clicking on the 'Script1' grey button.
The script example:
... see more - varies a fault resistance
- runs a simulation for each value
- exports results of a selected list of scope in MAT and ASCII formats
- returns Min and Max

Tag(s): script, script, ASCII, MAT, parametric, minimum, maximum

Author: h.gras
Type: Example
Downloaded: 97 times
Date: 2021-07-23

AC and DC components meter

Description:
This example contains a device which calculates the DC and AC components.
- The DC component is available in the DC control scope with half
a cycle delay versus the simulation time
- ... see moreThe AC component is available in the DC control scope with one
cycle delay versus the simulation time

Once the maximum DC magnitude is reached, the time constant is
determined assuming the DC decay is exponential and uninterrupted

Tag(s): DC, AC, exponential, meters, zero-crossing, asymmetry, fault

Author: n.sene
Type: Publication
Date: 2015-04-01

DISPERSED ENERGY RESOURCES SCHEDULING FOR THE INTENTIONAL ISLANDING OPERATION OF DISTRIBUTION SYSTEMS

Description:
The paper presents an algorithm for the automatic optimal scheduling of dispersed energy resources (DERs) and of under-load tap changers (ULTCs) position. The aim of the scheduling problem consists in... see more the minimization of the voltage deviations with respect the rated value, of the DERs production deviation with respect the maximum efficiency point, and of the network losses.
The system incorporates also a procedure to facilitate the intentional islanding maneuver of the distribution network. The adopted approach is based on iterative solution of linear-constrained multi-objective optimization problems. The nonlinear power flow relationships are linearized by means of the calculation of sensitivity coefficients to small variations of the control variables (namely, controllable DERs power outputs and ULTCs positions). The algorithm is implemented in Matlab environment to exploit different solvers and suitably interfaced with EMTP-RV for three-phase power flow detailed calculations. In particular, two optimization solvers are adopted: the least square method and the goal attainment approach. The relevant results are compared using the IEEE 34-node distribution feeder as test case.

Authors: A. Borghetti, C.A. Nucci, M. Paolone, M. Bosetti

Tag(s): Dispersed generation, active distribution networks, islanding operation.